![install rockchip driver windows 10 install rockchip driver windows 10](https://i.pinimg.com/736x/f1/03/2b/f1032ba6096ae5d0477e45f59334d7e0--factories-tools.jpg)
- #INSTALL ROCKCHIP DRIVER WINDOWS 10 INSTALL#
- #INSTALL ROCKCHIP DRIVER WINDOWS 10 DRIVERS#
- #INSTALL ROCKCHIP DRIVER WINDOWS 10 UPGRADE#
Once it’s finished, the device will reboot, Windows will install the adb drivers, and you should see the windows below. It will take a few minutes (It took 1204 seconds, or about 20 minutes). Click on “ Restore” (and not Update) to flash the firmware.update_mk908_100j1101_6210.img), and RKBatchTool should now indicate one device is connected by showing a green square in the “Connected Devices” section of the windows. Click on “…” at the top right of the window, select the firmware file (e.g.Now go to GEEKBUYING_Rockchip_Batch_Tool_v1.6/Rockchip_Batch_Tool_v1.6 and double click on RKBatchTool.exe to launch the tool.In Windows XP, you should see “ Class for rockusb devices->Rockusb Device” in the Device Manager. Click OK or Next to complete the installation.
#INSTALL ROCKCHIP DRIVER WINDOWS 10 DRIVERS#
There are different procedures depending on the version of Windows, but you should point the drivers installer to Rockusb_v3.5/Rockusb_v3.5/Rockusb/x86 (32-bit Windows) or Rockusb_v3.5/Rockusb_v3.5/Rockusb/圆4 (64-bit Windows) and finally select the directory corresponding to your Windows version.MK908 Recovery Button (Left) and OTG Port (Right) Wait a few seconds before releasing the recovery button, and your windows PC should start installing the drivers automatically, but you don’t want that, so don’t let it install the drivers now, and move to the next step. Press the recovery button with a paper clip, and at the same time insert the other end of the USB cable into the OTG port of your device. The right hole is the power LED, and the left hole, the recovery button.
![install rockchip driver windows 10 install rockchip driver windows 10](https://i0.wp.com/en.usb-driver.net/wp-content/uploads/2020/09/rockchip-driver-ok.png)
Now look at the back of MK908 with the HDMI connector pointing upwards, you should see 2 small holes at the top of the devices.
#INSTALL ROCKCHIP DRIVER WINDOWS 10 UPGRADE#
Typical users should not be asked to install software and drivers, press the recovery button, just to upgrade their firmware. This method should just be used in case the device can’t boot, or you have serious issue with the device firmware, but it is also used for firmware upgrade for Rockchip mini PCs. Those instructions only work on Windows operating systems, so if you’re using Linux or Mac, you’re out of luck until you find a Windows PC, or launch Windows in a virtual machine. This method use standard Rockchip tools, so it should work for any RK3188 devices.īut first a little rant. Yesterday, I’ve received MK908 mini PC featuring Rockchip RK3188, and a new firmware is available, so before further testing I’ll flash the firmware to the device basically using the instructions from Geekbuying.